Hitachi Global Link Manager Software Installation and Configuration Guide

Option description
Table 3-6 hcmds64dbuser Command Options
Option Description
/newpass password Specify the password to be used for authentication
when Global Link Manager accesses the database. The
value specified for this option becomes the new
authentication password.
If this option is omitted, you will be prompted to enter a
password.
Specifiable values: A string of the following characters
that is no more than 28 bytes
Characters can be used for the first character: A to Z, a
to z, \ (backslashes), @ (at marks), and # (number
signs)
Characters can be used for all other characters: A to Z,
a to z, 0 to 9, \ (backslashes), @ (at marks), and #
(number signs)
/default
Resets the authentication information to the default (for
both HiRDB and Hitachi Command Suite Common
Component resources).
If you specify this option while the system is being
changed to a cluster configuration or a database backup
is being restored, because the authentication
information is reset to the default, you do not need to
set the authentication information again, thus
simplifying operation.
Note
The hcmds64dbuser command can be executed even while a Hitachi
Command Suite Common Component is being executed.
Changing the IP Address or Host Name of the Global Link
Manager Server
If you change the IP address or host name of the management server on
which Global Link Manager is installed, you also need to change the settings
file for Hitachi Command Suite Common Component.
Changing the IP Address of the Global Link Manager Server
This section describes how to change the IP address of the management
server on which Global Link Manager is installed.
Note:
3-42
Setting Up Global Link Manager
Hitachi Global Link Manager Installation and Configuration Guide (Web Version)