Hitachi Global Link Manager Software Installation and Configuration Guide

7. In Cluster Administrator, place online the group to which the services
used by Global Link Manager have been registered.
Caution:
In the case you use Microsoft Failover Cluster, if HBase 64 Storage Mgmt
Web Service is not started, start HBase 64 Storage Mgmt Web Service by in
the Services panel, and place the service online by Failover Cluster
Management.
Installing a Global Link Manager Cluster for an Existing Installation
This section describes how to change to a cluster configuration after the
Global Link Manager system operations have started in a non-cluster
configuration. In this example, the instance of Global Link Manager whose
operations are already running is treated as the primary node.
When temporarily removing the cluster configuration of Global Link
Manager, and then changing to a cluster configuration again:
When Global Link Manager has already been running in a cluster
configuration, if you want to temporarily remove the cluster configuration,
and then change to a cluster configuration again, you need to perform the
following steps to set up a Global Link Manager cluster:
• On a primary node: steps 6 to 8 in
Installing a Global Link Manager
Cluster on the Primary Node on page 4-20
• On a secondary node: step 5 in Installing a Global Link Manager Cluster
on the Secondary Node on page 4-23
Caution:
• Before performing the procedure, make sure that the cluster management
IP address and shared disk are enabled on the primary node. If they are
not enabled, first perform the following procedures to place the resources
of the cluster management IP address and shared disk online.
Setting Up Microsoft Failover Cluster on page 4-9
• Make sure that the structure of the Global Link Manager installation folder
is the same for the primary and secondary nodes.
• If you execute the hcmds64dbclustersetup command in the following
procedure, the default (22032) is set to the port number that HiRDB uses.
Therefore, if you are using a port number other than the default to
perform operations, you need to reset the port number later. Write down
the port number you are using so that you can set the port number again.
• The space required for database-re-creation-destination-folder can be
calculated as follows:
required-space = database-capacity-for-Hitachi-Command-Suite-
Common-Component + database-capacity-for-all-Hitachi-Command-
Suite-products-installed-on-the-host-of-the-Global-Link-Manager
Installing Global Link Manager Clusters
4-19
Hitachi Global Link Manager Installation and Configuration Guide (Web Version)