Hitachi Global Link Manager Software Installation and Configuration Guide

Note: Do not execute two or more hcmds64dbclustersetup commands
concurrently. Do not execute the hcmds64dbclustersetup command and
the hcmds64getlogs command at the same time.
When Performing a New Installation of Global Link Manager in a Cluster
Configuration
1. Display cluster software.
Select Start, Control Panel, Administrative Tools, and then Failover
Cluster Management.
Then, use the cluster software to properly switch the group to which the
services of Hitachi Command Suite products have been registered to the
primary or secondary node on which Global Link Manager is to be
installed.
If Microsoft Failover Cluster is used (on OSs other than Windows Server
2012):
In Failover Cluster Management, right-click the resource group to
which the services used by Global Link Manager have been registered,
and then choose Move this service or application to another
node.
If Microsoft Failover Cluster is used (on Windows Server 2012):
In Failover Cluster Manager, right-click the role to which the services
used by Global Link Manager have been registered, choose Move, and
then Select Node.
2. On both the primary node and the secondary node, install Global Link
Manager, and then set up a cluster.
For details about how to install Global Link Manager and set up a cluster,
see
Installing Global Link Manager on the Primary Node on page 4-4 and
Installing Global Link Manager on the Secondary Node on page 4-7.
3. Configure cluster.
Please refer to next for the setting procedure of the cluster.
If Microsoft Failover Cluster is used:
Setting Up Microsoft Failover Cluster on page 4-9
4. If the following resources are registered, delete them.
¢
A resource in which HBase 64 Storage Mgmt Common Service has
been registered.
¢
A resource in which HBase 64 Storage Mgmt Web Service has been
registered.
5. Enable failover on the services that were set in step 1 of Removing a
Cluster Configuration on page 4-25, and then place the service online.
If Microsoft Failover Cluster is used (on OSs other than Windows Server
2012) :
In Failover Cluster Management, right-click the resource name, and
choose Properties, the Policies tab, then If resource fails. Attempt
4-28
Installing Global Link Manager Clusters
Hitachi Global Link Manager Installation and Configuration Guide (Web Version)