HP XP7 Business Continuity Manager Reference Guide (TK954-96004)

ManualsBrandsHP ManualsComputer AccessoriesHP P9500 Disk Array DKC Module-0 Controller Rack

101

102

103

104

105

106

107

108

109

110

Table 63 Contents of the Manage Path Set Panel

DescriptionItem

Specify an action.AC

• l: Executes the YKLOAD command and loads a path set.

• b: Executes the YKBLDPTH command, and establishes all logical paths in the selected

path set.

• d: Executes the YKBLDPTH command, and deletes all logical paths in the selected

path set.

• q: Executes the YKQRYPTH command, and displays the status of all logical paths in

the selected path set. The Path Set Status panel will be displayed.

• c: Executes the YKQRYPTH command with the RESTRUCT parameter specified.

When actions are entered in multiple AC columns, the actions are carried out in the order

displayed.

Path set IDPath Set ID

Execution result of the action specified for ACStatus

• NOT LOADED: the path set has not been loaded.

• LOAD ERROR RC=xx

: An error occurred during loading the path set.

• LOADED WITH WARNINGS RC=xx: The path set has not been loaded, but with

warnings.

• LOADED: Loading the path set was successful.

• Action-name SUCCESSFULLY: The action indicated by action-name was successful.

• Action-name WARNINGS command-name RC= xx: A warning occurred with the

command indicated by command-name, in the action indicated by action-name.

• Action-name WITH WARNINGS command-name RC=xx: The command indicated by

command-name within the action indicated by action-name generated an error

message.

• Action-name ERRORS command-name RC= xx The command indicated by

command-name terminated with an error.

A description of the path setDescription

xx is a return code from each command.

NOTE: Status displays the execution result of the action specified for AC. If you specify q for AC,

then the YKQRYPTH command is executed, and the status of each logical path that has been defined

in the path set is displayed in the Path Set Status panel. If you press the F3=Exit key to exit the Path

Set Status panel, Status in the Manage Path Set panel displays the execution result of the YKQRYPTH

command that was executed to display the Path Set Status panel.

Executing YKLOAD

When 1 is specified for the AC column in the Manage Path Set panel, the YKLOAD command (for

loading a path set) is executed. At this point, the LOAD Option panel is displayed for specifying

parameters for the YKLOAD command.

Figure 61 (page 106) shows the LOAD Option panel when a path set is loaded.

Manage Path Set Panel (Logical Path Management) 105