HP XP7 RAID Manager Reference Guide (T1610-96064)

AP: Number of active link paths of Continuous Access Journal.
U(%): Usage rate of journal volumes assuming the entire relevant volume is 100%.
Q-Marker: The PVOL journal volume shows the newest sequential number (Q-marker) at the time
of receiving WRITE data. The SVOL journal volume shows the newest sequential number (Q-marker)
written to the cache.
Q-CNT: Number of Q-markers remaining in the PVOL journal volume.
D-SZ(BLK): Capacity of the data block size of the journal volume in units of 512 bytes.
For details about the displayed capacity, see XP7 Continuous Access Journal User Guide.
Seq#: Serial number.
For XP7 Storage, the number of which 300,000 is added to the serial number is displayed.
Num: Number of LDEVs configuring the journal volume.
LDEV#: LDEV number.
DOW: Data Overflow Watch timer setting (in seconds) per the Journal.
PBW: Path Blockade Watch timer setting (in seconds) per the Journal. If the setting is more than
3600 seconds, it displays 6000 seconds.
APW: Active Path Watch timer setting (in seconds) to detect any link failures.
TYPE: Open or M/F system.
TTYPE: Timer type for mainframe: System or Local.
MODE: Status of the journal:
• HDD: Store the journal data to the journal volume (cache mode disabled).
• CACHE: Store the journal data to the cache (cache mode enabled).
IF: Inflow control for journal:
• E: Enable
• D: Disable
DOW(S): Data Overflow Watch timer setting (in seconds) per the Journal.
PBW(M): Path Blockade Watch timer setting (in minutes) per the Journal. If the setting is more than
60 minutes, it displays 100 minutes.
CR: Copy rate: Low, Medium, or High.
CS(bps): Copy speed in bps: 10 bps, 100 bps, or 256 bps.
DM: Copy mode "Y" or "N" under failure of the delta resync:
• Y: copying ALL data.
• N: No copying.
MP#: MP blade ID.
raidcom modify journal
Changes the option of Continuous Access Journal to be used at journal, and sets the specified
control parameter to the journal.
If you specify the -mp_blade_id option, you cannot specify the other options (-data_overflow_watch,
- path_blocked_watch, -cache_mode, or -timer_type).
The -timer_type option must be specified to the journal on mainframe systems. This means that this
option cannot be used for changing from "Open System" to "M/F System".
158 Configuration setting commands