Hitachi Global Link Manager Software Installation and Configuration Guide

replacement process. In Hitachi Command Suite products, you can migrate
the database by using the hcmds64dbtrans command. The hcmds64dbtrans
command migrates all information stored in the database of each Hitachi
Command Suite product as well as user information managed by the Hitachi
Command Suite Common Component.
In the following two cases, you can use the hcmds64dbtrans command to
migrate the Global Link Manager database to a machine that has a different
environment from the one on the currently operating server machine:
• Migration to a machine on which the installation locations for Hitachi
Command Suite products are different from the ones on the migration
source
• Migration to a machine on which the versions of Hitachi Command Suite
products are newer than the ones on the migration source
Notes When Migrating the Database
The following are notes for the types, versions, and user information of the
Hitachi Command Suite products on the migration source and migration
destination servers.
Notes for types and versions of the Hitachi Command Suite products
on the migration source and migration destination servers:
• The database of a Hitachi Command Suite product that is not installed on
the migration destination server cannot be migrated. Install all necessary
Hitachi Command Suite products on the migration destination server.
• If any of the versions of the Hitachi Command Suite products installed on
the migration destination server is older than the ones on the migration
source server, the database cannot be migrated. On the migration
destination server, install the Hitachi Command Suite products whose
versions are the same as or higher than the ones on the migration source
server.
• If you migrate the database of Replication Monitor version 4.2 or earlier,
upgrade Replication Monitor on the source and destination servers to
version 5.0 or later in advance.
• If you migrate the Replication Monitor database to the Replication
Manager database, first upgrade Replication Monitor on the source server
to Replication Manager, and then migrate the database.
• The following limitations apply when you migrate the Tuning Manager
database:
¢
If the version of Tuning Manager is earlier than 6.0, first upgrade the
Tuning Manager to version 6.0 or later on both the migration source
and migration destination servers.
¢
Set the same capacity for the Tuning Manager database on both the
migration source and migration destination servers. For details on
how to change the capacity of the database, see the Hitachi Command
Suite Tuning Manager Server Administration Guide.
3-14
Setting Up Global Link Manager
Hitachi Global Link Manager Installation and Configuration Guide (Web Version)