HP XP7 Business Continuity Manager Release Notes (TK954-96001)

Table 16 Overview of CLI commands (continued)
RemarksDifferences from previous version4x4x4 configurationCLI command
Local and the Remote sites to
re-register them to EXCTG.
to such copy pairs causes the
YKZ296E error message to occur.
Not applicableNot applicableYKDELPTH
NoneSupportedYKEWAIT
Not applicableNot applicableYKFCSTAT
NoneSupportedYKFREEZE
NoneSupportedYKLOAD
NoneSupportedYKMAKE
NoneSupportedYKQRYDEV
Not applicableNot applicableYKQRYPTH
NoneSupportedYKQUERY
If this situation occurs, issue either
the YKMAKE command with the
After performing Delta Resync, if
the Delta Resync copy pairs
between the Primary and Remote
SupportedYKRECVER
HOLD parameter to the Delta
sites are dissolved, EXCTG
Resync copy pairs between the
information of Cnt Ac-J copy pairs
Primary and Remote sites, or the
between the Local and Remote
YKMAKE command with the
sites is also deleted. Therefore,
SELECT(COND) parameter to Cnt
issuing the YKQUERY command
Ac-J copy pairs between the Local
to such copy pairs causes the
YKZ296E error message to occur.
and Remote sites to re-register them
to EXCTG.
NoneSupportedYKRESYNC
NoneSupportedYKRUN
Not applicableNot applicableYKSCAN
Not applicableNot applicableYKSLEEP
NoneSupportedYKSTATS
NoneSupportedYKSTORE
NoneSupportedYKSUSPND
NoneSupportedYKWATCH
Setup procedure of 4x4x4 Multi-Target configuration with Delta Resync is equivalent to that of 4x4
configuration and 3DC Multi-Target configuration with Delta Resync except that there are some
restrictions on definition of Cnt Ac-S and 4x4 Cnt Ac-J.
Operation of 4x4x4 Multi-Target configuration with Delta Resync is same as that of 4x4 configuration
and 3DC Multi-Target configuration with Delta Resync.
Overview of CLI commands for 4x4x4 Multi-Target configuration with Delta Resync 17