HP XP7 RAID Manager Reference Guide (T1610-96064)

DescriptionOption
Note: If there have not been any changes to the specified volumes, this option displays nothing.
For XP7, the number of which 300,000 is added to the serial number is displayed.
Specifies the following operation that displays each parameter for validation checking:-v [op]
• cflag: Displays all flags for checking regarding data block validation for target vols.
• offset: Displays the range setting for data block size of Oracle I/O and a region on a target
volume for validation checking.
• errcnt: Displays the statistical information counted as an error for each checking on the target
volumes. Each statistical information counted as an error is cleared when the individual flag
for validation checking is disabled.
• gflag: Displays the parameter for guarding on the specified target volumes.
• pool: This option displays the capacity and the usable capacity of the Snapshot pool
corresponding to the group. Usually, this option displays the pool capacity and the usable
capacity for the pool ID of which the group is belonging because pool ID is specified in pair
creation with group. This is needed to help the decision whether the restore operation is
possible or not, because the pool capacity is consumed by the restore operation of the
Snapshot.
• aou[b]: Displays the LUN capacity and usage rate for Thin Provisioning volume corresponding
to the group of RM configuration file, and displays the ID of the pool to which LDEV belongs.
• aoub: Displays the LUN capacity in units of block(512 bytes).
Returned values
--
Error codes
--
Examples
Example 1
Example of raidvchkdsp command with -fd option:
raidvchkdsp -g vg01 -fd -v cflag
Group PairVol Device_File Seq# LDEV# BR-W-E-E MR-W-B BR-W-B
SR-W-B-S
vg01 oradb1 Unknown 2332 - - - - - - - - - - -
- - - -
vg01 oradb2 c4t0d3 2332 3 D E B R D D D D E E
D E D D
Example 2
Example of raidvchkdsp command with -fe option and its output:
# raidvchkdsp -g horc0 -v gflag -fe
Group... TID LU Seq# LDEV# GI-C-R-W-S PI-C-R-W-S R-Time EM E-Seq# E-LDEV#
horc0... 0 20 63528 65 E E E E E E E E E E 0 - -
-
horc0... 0 20 63528 66 E E E E E E E E E E 0 - -
-
Output of the raidvchkdsp command with -fe option:
EM: external connection mode.
• H = Mapped E-lun is hidden from the host.
• V = Mapped E-lun is visible to the host.
• — = Unmapped to the E-lun.
82 Data management commands