HP XP7 RAID Manager User Guide (T1610-96063)

Table 91 SSB codes that are returned by raidcom delete rcu command (continued)
raidcom delete rcu
DescriptionError codeExecuting/
Async
Error message
SSB2SSB1
The serial number, the product ID, or the SSID of the target
storage system is incorrect.
30002E20AsyncGet Command Status
The specified RCU cannot be deleted because the RCU is not
registered.
30012E20AsyncGet Command Status
The specified CU number is not defined, or an LDEV is not
defined under the CU number.
71012E21AsyncGet Command Status
Path cannot be deleted because there is a pair of Continuous
Access Synchronous/Continuous Access Journal, or a journal
volume is in the relevant CU.
31012E22AsyncGet Command Status
Command cannot be executed because the RCU identification
code of a path is invalid.
30012E31AsyncGet Command Status
The command cannot be accepted because the DKC is busy.
After a while, execute the same command.
00EE2ED6ExecutingCMDRJE
An internal error occurred.30052ED6AsyncGet Command Status
Call HP Technical Support.
The value of SSID on the remote storage system is invalid.33002ED6ExecutingCMDRJE
RCU storage system does not exist.00D12EDEExecutingCMDRJE
The specified parameter is invalid. Check the HP XP7 RAID
Manager Reference Guide.
30022EF3ExecutingCMDRJE
Table 92 SSB codes that are returned by raidcom add rcu command
raidcom add rcu
DescriptionError codeExecuting/
Async
Error message
SSB2SSB1
The value of CU# on the RCU exceeds the effective range.30012E00ExecutingCMDRJE
Invalid product ID or path registration ID.30052E00ExecutingCMDRJE
Command cannot be executed because the parameter of
specified RCU is invalid.
30082E00AsyncGet Command Status
Command cannot be executed because all the CU numbers in
the RCU is not unified at the path that is specified creation or
deletion.
30092E00AsyncGet Command Status
The value of port# on the side of RCU is invalid.32002E00ExecutingCMDRJE
The CU number is out of effective range.71002E00ExecutingCMDRJE
/AsyncGet Command Status
The value of specified port is invalid.84002E00ExecutingCMDRJE
/AsyncGet Command Status
Failed to establish a path or the deletion operation. The following
factor can be thought.
31012E10AsyncGet Command Status
• Input parameter is invalid.
• Port status or the MP Blade status is in the state of abnormal.
280 Troubleshooting