HP XP7 Remote Web Console Messages (H6F56-96010)

Table 56 Error codes (part code 06005) (continued)
Severity
Level
Recommended ActionError MessageError
Number
Part
Code
WSpecify a different volume.The pair cannot be created because the
specified primary volume is a command
device.
00898206005
WSpecify a different volume.The pair cannot be created because the
specified secondary volume is a
command device.
00898306005
WVerify if the specified primary volume meets any
of the reasons described in the message.
The specified primary volume is a
volume used by Compatible FlashCopy
00898906005
or Compatible FlashCopy SE. The
operation cannot be performed due to
one of the following reasons.
• The current microcode cannot use a
volume used by Compatible
FlashCopy as a primary volume.
• The current microcode cannot use a
volume used by Compatible
FlashCopy SE as a primary volume.
• The primary volume is a TSE volume.
• "Cylinder" is set for the "Differential
Management" of the primary volume.
• The primary volume belongs to a
Sync Group.
WSpecify volumes that can be used to create a pair,
and then retry the operation.
The pair cannot be created because the
specified secondary volume is used by
00899006005
Compatible FlashCopy or Compatible
FlashCopy SE, or is a TSE volume.
EIf the problem persists despite retrying, please
contact HP Technical Support.
An error occurred during SVP
processing.
05700506005
WRemove the storage system that does not support
the specified pair configuration, or specify a
different volume, and then retry the operation.
The pair operation cannot be performed
due to one of the following reasons.
05831906005
• The specified primary volume is used
by Continuous Access Journal or
Continuous Access Journal Z.
• A storage system that does not
support the specified pair
configuration is included.
WIf the Create Pairs operation cannot be performed,
take the following action:
The pair operation cannot be performed
due to one of the following reasons.
05832006005
• If the remote storage system is in a 2DC
configuration in which Continuous Access
• The specified secondary volume is
used by Continuous Access Journal
or Continuous Access Journal Z. Journal or Continuous Access Journal Z is
combined with Continuous Access
• A storage system that does not
support the specified pair
configuration is included.
Synchronous or Continuous Access
Synchronous Z, wait until the status of the
Continuous Access Journal or Continuous
Access Journal Z pair changes to "PAIR", and
then retry the operation.
• If the remote storage system is not in a 2DC
configuration, specify a different volume for
the secondary volume, and then retry the
operation.
• If one of the storage systems does not support
the specified pair configuration, remove the
storage system, and then retry the operation.
160 Message (part code group 06nnn)