HP XP7 Remote Web Console Messages (H6F56-96010)

Table 31 Error codes (part code 01005) (continued)
Severity
Level
Recommended ActionError MessageError
Number
Part
Code
WSpecify a different volume, and then retry the
operation.
When registering WWN, the value is
not specified. Or, zero is set as the value
00111601005
of WWN. Be sure to set the WWN
value before requesting the configuration
change.
WThe configuration information has been already
changed. Check the settings, and request the
setting of the configuration information again.
Command device security cannot be set
to the specified volume because the
volume is not a command device.
00112301005
WThe configuration information has been already
changed. Check the settings, and request the
setting of the configuration information again.
There are no host groups where the
WWN will be registered.
00112501005
WSpecify a different volume, and then retry the
operation.
The specified channel speed cannot be
set for the target channel adapter.
00112801005
WCorrect the specified contents, and request again.You cannot specify the default nickname
when setting the nickname of a host
group or a host.
00113001005
WNo more host groups can be set, because the
number of host groups has reached the maximum
Failed to set the host group because the
number of host groups exceeds the
maximum that can be set in a port.
00113101005
(254) that can be set in a port. Reduce the
number of host groups, then retry the operation.
WThe configuration information has been already
changed. Check the settings, and request the
setting of the configuration information again.
Failed to set the WWN because the
number of WWNs exceeds the
maximum that can be set in a port.
00113201005
WThe configuration information has been already
changed. Check the settings, and request the
setting of the configuration information again.
Failed to set the host mode because the
number of host modes exceeds the
maximum that can be set in a port.
00113301005
WThe configuration information has been already
changed. Check the settings, and request the
setting of the configuration information again.
Error happened before the change was
processed. Failed to set the path
because the number of paths exceeds
the maximum that can be set in a port.
00113401005
WSpecify a different volume, and then retry the
operation.
Error happened before the change was
processed. When setting the port
00113501005
information (Fibre Address/Fibre
Topology/Channel Speed), multiple
change instructions are set to the same
port.
WThe specified port does not exist. You have
specified a wrong port number. Or the specified
You specified same setting using LUNM
operation.
00113801005
port type (exclusively for mainframe) cannot be
processed in this agent. The error does not occur
normally because it cannot be modified in the
window. In the unlikely event that this error
occurs, please contact HP Technical Support.
WRelease the Port Group setting.Because the Port Group setting is done,
it is impossible to change.
00114001005
WCorrect settings, then retry.Error happened after some change
occurred.
00117001005
Please refresh the array configuration.
The volume cannot be configured as a
command device because the volume
does not have Read/Write attribute.
Part code 01005 63