Hitachi Dynamic Link Manager Software Users Guide for Solaris

ManualsBrandsHP ManualsComputer AccessoriesHP P9500 Disk Array Upgrade DKC Module-1 Controller Rack

471

472

473

474

475

476

477

478

479

480

Log file

The installux.sh utility outputs execution information to the log

file /var/tmp/hdlm_installux_sh.log. If the hdlm_installux_sh.log log

file already exists, the utility appends execution information onto the end of

the log file.

If the size of the log file is equal to or greater than 1 MB when the utility is

executed, the log file is renamed to hdlm_installux_sh2.log, and a new log

file is created and named hdlm_installux_sh.log, to which the execution

information is output.

Note

The hdlm_installux_sh.log and hdlm_installux_sh2.log log files are not

deleted when HDLM is removed. Manually delete the log files, if they are no

longer required.

Note

• If VxVM is installed on the host, do not use the -r option or the -t option.

Perform the installation without specifying any options.

After the installation has finished, perform the following steps to configure

the HDLM device:

Execute the following dlmsetconf utility:

# /opt/DynamicLinkManager/bin/dlmsetconf

To disable devices in VxVM, follow the procedure outlined in

Removing

Devices from VxVM on a Controller Basis on page 3-162 or Removing

Devices From VxVM on a Path Basis on page 3-166 of Removing

Devices from VxVM on page 3-160.

To activate the settings and to make the host recognize HDLM

devices, restart the host with the reconfiguration option specified.

Execute one of the following commands:

# reboot -- -r

At the ok prompt, execute the following:

boot -r

• If HDLM devices are used in a cluster (such as VCS or Sun Cluster (Oracle

Solaris Cluster)), do not use the -r option or the -t option.