Hitachi Global Link Manager Software Installation and Configuration Guide

6. Change the host name for the management server, and then restart the
computer.
If you have changed the host name for the management server before
changing the settings file for Hitachi Command Suite Common
Component, restart the computer.
7. Execute the following command to make sure that Hitachi Command
Suite Common Component is running:
Hitachi-Command-Suite-Common-Component-installation-folder\bin
\hcmds64srv /status
8. If a host name is used for the URL for logging into Global Link Manager,
change the settings.
For details on how to use the hcmds64chgurl command, see
Changing
the Global Link Manager Login URL on page 3-50.
Note that, if you change the host name of the management server, you need
to check and, if necessary, revise the settings for each Hitachi Command
Suite product. For details about the settings that need to be changed, see
Settings Required After Changing the IP Address or Host Name of the Global
Link Manager Server on page 3-45.
Settings Required After Changing the IP Address or Host Name of
the Global Link Manager Server
This section describes the settings required in Global Link Manager after you
change the IP address or host name of the management server on which the
Global Link Manager server is installed. For details about the settings for
other Hitachi Command Suite products installed on the same server, see the
manual for each product.
In Global Link Manager, check and revise the following settings:
List of hosts
Use the Global Link Manager GUI to re-register hosts in the list of hosts.
If you do not re-register the hosts, you will not receive alerts. To re-
register hosts, you have to delete all of the hosts from the list of hosts,
and then add the hosts again. For details about the list of hosts in the
Global Link Manager GUI, see Help.
Also, depending on the operating environment, you might need to check and
revise the following settings:
If a RADIUS server is used to authenticate accounts
Check the settings in the exauth.properties file.
Changing Hitachi Command Suite Common Component Port
Numbers
The following table lists and describes the port numbers used by Hitachi
Command Suite Common Component:
Setting Up Global Link Manager
3-45
Hitachi Global Link Manager Installation and Configuration Guide (Web Version)