Hitachi Global Link Manager Software Installation and Configuration Guide

uses. Therefore, if you are using a port number other than the default
to perform operations, you need to reset the port number later. Write
down the port number you are using so that you can set the port
number again.
¢
The space required for database-re-creation-destination-folder can be
calculated as follows:
required-space = database-capacity-for-Hitachi-Command-Suite-
Common-Component + database-capacity-for-all-Hitachi-Command-
Suite-products-installed-on-the-host-of-the-Global-Link-
Manager (including the Global Link Manager database)
If the hcmds64dbclustersetup command execution fails because
there is not enough space for database-re-creation-destination-folder,
increase the space for the folder, and then re-execute the command.
¢
Do not disconnect the shared disk from the executing node until
execution of the hcmds64dbclustersetup command terminates
normally.
¢
If execution of the hcmds64dbclustersetup command terminated
abnormally and then you restart the server, the connection target of
the shared disk might be changed to the standby node.
Reinstallation or Version Upgrade Installation of Global Link Manager on the
Primary Node
1. Display cluster software
Select Start, Control Panel, Administrative Tools, and then Failover
Cluster Management.
2. Switch the group to which the services used by Global Link Manager have
been registered to the executing system.
Global Link Manager uses the following services:
¢
HBase 64 Storage Mgmt Common Service
¢
HBase 64 Storage Mgmt SSO Service
¢
HBase 64 Storage Mgmt Web Service
¢
HBase 64 Storage Mgmt Web SSO Service
¢
HiRDB/ClusterService _HD1
If Microsoft Failover Cluster (on OSs other than Windows Server 2012) is
used:
In Failover Cluster Management, right-click the resource group to
which the services used by Global Link Manager have been registered,
and then choose Move this service or application to another
node.
If Microsoft Failover Cluster is used (on Windows Server 2012):
In Failover Cluster Manager, right-click the role to which the services
used by Global Link Manager have been registered, choose Move and
then Select Node.
4-12
Installing Global Link Manager Clusters
Hitachi Global Link Manager Installation and Configuration Guide (Web Version)