Hitachi Global Link Manager Software Installation and Configuration Guide

An IP address cannot be specified for virtualhost, onlinehost, or
standbyhost. Make sure that the IP address can be resolved from the
host name.
The following shows a coding example in the cluster-configuration file:
mode = standby
virtualhost = hicommand_cluster
onlinehost = hicommand_1
standbyhost = hicommand_2
Save the created file as cluster.conf in Hitachi-Command-Suite-
Common-Component-installation-folder\conf.
¢
Migrate the database to the shared disk.
Execute the following command:
Hitachi-Command-Suite-Common-Component-installation-folder\bin
\hcmds64dbclustersetup /createcluster /databasepath target-
folder-for-re-creating-the-database /exportpath target-folder-
for-storing-data /auto
Before executing the command, either delete target-folder-for-
recreating-the-database and target-folder-for-storing-data or make
sure that the two folders are empty.
On the shared disk, deploy the folder in which the database is to be
recreated. On the local disk, deploy the folder that stores data.
Specify an absolute path (maximum of 63 bytes) for target-folder-for-
recreating-the-database and target-folder-for-storing-data.
You can use the following characters for target-folder-for-re-creating-
the-database and target-folder-for-storing-data:
A to Z, a to z, 0 to 9, period (.), and underscore (_). You can also use
a backslash (\), colon (:), and forward slash (/) as the path delimiter.
When the /auto option is used, the system automatically stops
Hitachi Command Suite Common Component and starts HiRDB. After
the command is executed, both Hitachi Command Suite Common
Component and HiRDB are stopped. Depending on the machine
performance, the command is executed before HiRDB has completely
started, and then the KAPM06587-E message appears indicating that
the export processing has failed. In this case, manually start HiRDB,
and then execute the hcmds64dbclustersetup command without
specifying the /auto option.
To start HiRDB, execute:
Hitachi-Command-Suite-Common-Component-installation-folder\bin
\hcmds64dbsrv /start
Note: Do not execute two or more hcmds64dbclustersetup
commands concurrently. Do not execute the hcmds64dbclustersetup
command and the hcmds64getlogs command at the same time.
¢
If the port number that HiRDB uses has already been changed and is
being used, reset the port number. When the
hcmds64dbclustersetup command is executed, the default (22032) is
Installing Global Link Manager Clusters
4-17
Hitachi Global Link Manager Installation and Configuration Guide (Web Version)