Hitachi Global Link Manager Software Installation and Configuration Guide

¢
HBase 64 Storage Mgmt Web Service
¢
HBase 64 Storage Mgmt Web SSO Service
¢
HiRDB/ClusterService _HD1
7. If the port number that HiRDB uses has already been changed and is
being used, reset the port number.
When the hcmds64dbclustersetup command is executed, the default
(22032) is set to the port number that HiRDB uses. Therefore, reset the
port number.
8. Configure cluster.
Please refer to next for the setting procedure of the cluster.
Setting Up Microsoft Failover Cluster on page 4-9
Installing a Global Link Manager Cluster with other Hitachi
Command Suite Clusters Installed
This section describes how to perform a new installation of Global Link
Manager in an environment where other Hitachi Command Suite products are
running in a cluster configuration.
If you perform a reinstallation or version upgrade installation of Global Link
Manager in an environment where Global Link Manager is running in a cluster
configuration together with other Hitachi Command Suite products, see
Reinstallation or Version Upgrade Installation of Global Link Manager in a
Cluster Environment on page 4-11.
For details about the settings for a cluster environment for other Hitachi
Command Suite products, see the corresponding manual for those products.
Note: If you execute the hcmdsdbremake or hcmds64dbclustersetup
command in the following procedure, the default (22032) is set to the port
number that HiRDB uses. Therefore, if you are using a port number other
than the default to perform operations, you need to reset the port number
later. Write down the port number you are using so that you can set the port
number again.
Removing a Cluster Configuration
1. Remove the services of Hitachi Command Suite products (HiRDB/
ClusterService _HD1, HBase 64 Storage Mgmt Common Service, HBase
64 Storage Mgmt SSO Service, HBase 64 Storage Mgmt Web Service,
HBase 64 Storage Mgmt Web SSO Service, and of other Hitachi Command
Suite products) and failover of cluster groups.
¢
In Failover Cluster Management, place the target services offline.
¢
In Failover Cluster Management, right-click the resource name, and
choose Properties, the Policies tab, then If resource fails, do not
restart.
2. Stop all Hitachi Command Suite products in both the primary and
secondary nodes.
Installing Global Link Manager Clusters
4-25
Hitachi Global Link Manager Installation and Configuration Guide (Web Version)