Hitachi Global Link Manager Software Installation and Configuration Guide

Figure 1-3 Flow of Global Link Manager Tasks
Installing multipath management software and setting up its environment
Set up multipath management software on all hosts that are integrated
and managed by Global Link Manager. For details about the requirements
for installing the multipath management software on a host, see
Host
Requirements on page 1-13. For details about the procedures for
installation and environment setup of the multipath management
software at each host, see the documentation for the applicable multipath
management software.
Configure the following on all hosts, according to the version of the
multipath management software that has been set up:
¢
When the HDLM version of a host is earlier than 5.8:
To use Global Link Manager to manage HDLM, you must use a Device
Manager agent. The procedure for setting up the Device Manager
agent differs depending on the version of the Device Manager agent
and the host OS. For details about the installation and setup
1-18
Global Link Manager System Configuration and Requirements
Hitachi Global Link Manager Installation and Configuration Guide (Web Version)