HP XP7 Business Continuity Manager Messages (TK954-96003)

Table 1 Business Continuity Manager error messages and corresponding troubleshooting actions
(message ID YK70x –YK90x) (continued)
Explanation and recommended actionsMessage textMessage ID
contents-of-register-2
contents-of-register-3
y'y'.m'm'.d'd' and bbbbbbbb are
invalid.
GR 04-07
contents-of-register-4
module-creation-date
This is displayed in one of the following formats:
contents-of-register-5
contents-of-register-6
contents-of-register-7
• y'y'.m'm'.d'd' : Creation date of the module identified by
module-name
GR 08-11
contents-of-register-8
• y'y'.m'm'.d'd' : Creation date of the module identified by
module-name
contents-of-register-9
bbbbbbbb
contents-of-register-10
contents-of-register-11
Contents of the base register
GR 12-15
contents-of-register-12
dddd
• ABENDED-MODULE: Location where ABENDED-MODULE was
called, relative to the top of the module
contents-of-register-13
contents-of-register-14
contents-of-register-15
• CALLING-MODULE: Location where CALLING-MODULE was
called, relative to the top of the module
pppppppp pppppppp
PSW during the abnormal termination
ll
Length of the command during the abnormal
termination
xx
Interrupt code during the abnormal termination
The value identified by error-type, which was specified in the
command-name command, is invalid.
The specified error-type
is invalid: command-name.
YK8031W CON
error-type
• label: The label name is invalid. Check the label name for
ACTION=STOPPOINT specified in the YKMONCG file.
• copy group: The copy group ID is invalid. Check the copy
group ID for CGID specified in the YKMONCG file.
BCM Monitor will stop at the point label.time BCM Monitor will stop
at STOPPOINT 'label'.
YK8040I PRT CON
time
Message output time
This is only displayed when the output
destination is SYSTSPRT.
label
Label at which BCM Monitor stops
BCM Monitor will stop at the end of a cycle.time BCM Monitor will stop
at the end of monitor cycle.
YK8041I PRT CON
time
Message output time
This is only displayed when the output
destination is SYSTSPRT.
BCM Monitor will go to sleep at the point label.time BCM Monitor will
sleep at STOPPOINT 'label'
YK8042I PRT CON
12 Messages