HP XP7 Business Continuity Manager Messages (TK954-96003)

Table 55 Details of error codes 50xx – 6Exx (continued)
Type of errorError detailsError
code
OthersTHPzPATHCMDCAJCAACABC
Not outputOutputNot outputA command device cannot be
defined because the APID
64FF
specified by the parameter does
not match the APID defined for
the command device.
OutputNot outputOutputNot outputA parameter error occurred. This
error might occur during a
69E4
storage system configuration
change or operation after the
microcode is changed. If this
occurs, scan the storage system
by using Business Continuity
Manager to obtain volume
information again.
Not outputOutputNot outputA path cannot be deleted because
there is an invalid parameter.
69E6
OutputNot outputThe command cannot be
executed. The reason might be
one of the following:
69E7
• The command cannot be
executed because the specified
volume does not exist.
• The Protection attribute has
been set by Hitachi Volume
Retention Manager software.
OutputNot outputThe command cannot be executed
because the specified volume is
blocked.
69E8
Not outputOutputNot outputThe command cannot be
executed. The reason might be
one of the following:
69E9
• The corresponding volume is
in the SIMPLEX status.
• The corresponding volume is
not part of a CAA copy pair.
• The corresponding volume is
not a P-VOL.
Not outputOutputNot outputA path cannot be established
because there is an invalid
parameter.
69F2
• The storage system serial
number is incorrect.
• The SSID is incorrect.
• The CU number is not
supported.
202 Storage system sense byte information