HP XP7 Business Continuity Manager Messages (TK954-96003)

Table 2 Business Continuity Manager error messages and corresponding troubleshooting actions
(message ID YKA0x – YKB20x) (continued)
Explanation and recommended actionsMessage textMessage ID
No copy pair information was acquired from the volume to which
the device number Devn was assigned because no I/O paths are
available. Verify the I/O path settings.
No I/O paths are available
for the specified devices.
DEVN=Devn
YKB201W TSO
Devn
The device number of the volume whose
information acquisition was skipped
A P-VOL not defined in the disk configuration definition file was
detected among the PPRC copy pairs detected by the YKP2B
command.
Unable to resolve primary
volume information.
Pair=CopyType,
DEVN=Devn,
YKB202W TSO
Check whether the detected P-VOL is defined in the disk
configuration definition file.
SN=SerialNum, CU=CU#,
CCA= CCA#
CopyType
The copy type of the detected undefined volume
Devn
The device number of the detected undefined
volume
SerialNum
The storage system serial number of the detected
undefined volume
CU#
The control unit number of the detected
undefined volume
CCA#
The command control address number of the
detected undefined volume
An S-VOL not defined in the disk configuration definition file was
detected among the PPRC copy pairs detected by the YKP2B
command.
Unable to resolve secondary
volume information.
Pair=CopyType,
SN=SerialNum, CU=CU#,
CCA= CCA#
YKB203W TSO
Check whether the detected S-VOL is defined in the disk
configuration definition file.
CopyType
The copy type of the detected undefined volume
SerialNum
The storage system serial number of the detected
undefined volume
CU#
The control unit number of the detected
undefined volume
CCA#
The command control address number of the
detected undefined volume
A dynamic change was detected in an I/O configuration definition
while the YKP2B command was executing with CHECK specified
for the HS parameter.
A dynamic configuration
change was detected.
DEVN=device-number
YKB204W TSO
Check the status of the device targeted by the YKP2B command,
correct any errors in the configuration or execution conditions, and
then re-execute the command.
device-number
32 Messages