HP XP7 Business Continuity Manager Reference Guide (TK954-96004)

The message structure is initialized when the CLI command with the same name as the MSG
parameter is specified.
{FORWARD|REVERSE}
Specify the copy direction.
FORWARD
The command makes a copy pair directed from the primary site to the secondary site.
REVERSE
Makes a copy pair in the reverse direction, from the secondary site to the primary site.
NOCOPY
Applies to Continuous Access Synchronous for Mainframe, Continuous Access Asynchronous for
Mainframe, and Continuous Access Journal for Mainframe.
The command makes a copy pair without copying between P-VOL and S-VOL. The command is
used only when the two volume status are exactly the same.
HOLD
Applies to Continuous Access Journal for Mainframe.
The copy pair status is transitioned to the HOLD status.
SELECT({ALL|COND})
Specify the selection method for the copy pair to be manipulated by the command. When not
specified, ALL is assumed.
ALL
All the copy pairs in the copy group are to be manipulated by the command. Note that if the DEVN
parameter is specified, the copy pair specified for the parameter is the execution target of the
command.
COND
The pairs to be manipulated by the command depend on their volume status. For more information,
see the table regarding copy pair statuses that are manipulated by the command in the HP XP7
for Business Continuity Manager User Guide.
For CG containers specified by EXCTG ID, journal groups not registered in EXCTG are registered
even if there is no volume that is manipulated by the command.
DEVN(p-vol-device-number,s-vol-device-number) ~ <4-digit hexadecimal number, 4-digit
hexadecimal number>
Specify the device number of the copy pair (P-VOL and S-VOL) to operate.
If this parameter is specified for a CG container specified by EXCTG ID, the following operations
are performed because journal groups are not registered in EXCTG.
222 CLI Commands