HP XP7 Business Continuity Manager User Guide (TK954-96005)

Table 42 How to Prepare the Configuration Files at each site (3DC Cascade (Cnt Ac-S Z x Cnt Ac-J
Z) Configuration) (continued)
How to PrepareContentsFile Type
At the Secondary SiteAt the Primary Site
Not requiredDefine a path setPath set definition
file
• An inter-control unit logical path from the
primary site to the intermediate site
• An inter-disk controller logical path from
the intermediate site to the remote site
Define a path setNot required
• An inter-control unit logical path from the
intermediate site to the primary site
• An inter-disk controller logical path from
the remote site to the intermediate site
Not requiredDefine a route listA route/command device from the primary
site, to the intermediate site, and then the
remote site
Route list definition
file/Command
device definition
file
Define a route listNot requiredA route/command device from the remote
site, to the intermediate site, and then the
primary site
Transfer from the primary
site
Define a copy groupA Cnt Ac-S Z copy groupCopy group
definition file
Define a copy groupA Cnt Ac-J Z copy group
NOTE: If you define the route list, the route list definition file and the command device definition
file will be created at the same time.
Definition procedure (3DC Cascade (Cnt Ac-S Z x Cnt Ac-J Z) configuration)
First, set the items that need to be set by using Remote Web Console from among the items listed
in Table 39 (page 155).
This section explains how to set up a 3DC Cascade (Cnt Ac-S Z x Cnt Ac-J Z) configuration from
the ISPF panel.
The following shows the legend for the figure in the operation procedure of this section:
Defining a 3DC Cascade (Cnt Ac-S Z x Cnt Ac-J Z) configuration 157