HP XP7 External Storage for Open and Mainframe Systems User Guide (TK914-96001)

Set system parameters according to the following table. For connection parameters not shown,
refer to Fujitsu FibreCAT CX series documentation.
Parameter SettingParameter
CLARiiON OpenInitiator Type
2Failover Mode
Volumes created with the RAID0 level or Individual Disk Units (JBOD disks) of Fujitsu FibreCAT CX
series are not supported.
System option mode for connecting Fujitsu FibreCAT CX series
When you connect the Fujitsu FibreCAT CX series as an external storage system, you must set SOM
725 of the local storage system to ON. If SOM 725 is not set to ON, the external storage system
might be blocked when a maintenance task such as rebooting the controller of the external storage
system is performed before the firmware update..
For worldwide technical support information, see the HP support website: http://www.hp.com/
support.
Fujitsu DX60/80/90 S2 and Fujitsu DX400 S2
The port must be configured as a target attached to a Windows host.
Set system parameters according to the following table. For connection parameters not shown,
refer to Fujitsu DX60/80/90 S2 or Fujitsu DX 400 S2 documentation.
Parameter SettingParameter
Type1 + Type3Inquiry VPD ID Type in Setup Host Response screen
BusyLoad Balance Response in Setup Host Response screen
SGI IS4600 series
The port must be configured as a target attached to a Windows host.
Set system parameters according to the following table. For connection parameters not shown,
refer to SGI IS4600 series documentation.
Parameter SettingParameter
When alternate paths are connected to different clusters
on the SGI IS4600 series side: Linux
host type
3Par T800, F400, V800, V400 series
The port must be configured as a target attached to a windows host.
Set system parameters according to the following tables. For connection parameters not shown,
refer to 3Par T800, F400, V800 or V400 series documentation.
For 3Par T800 and F400 series
Parameter SettingParameter
generic-legacy (or generic)host mode
Fujitsu DX60/80/90 S2 and Fujitsu DX400 S2 91