HP XP7 RAID Manager Reference Guide (T1610-96064)

• - ERR_80: RCU Port Number Mismatch
• - ERR_81: RCU Port Type Mismatch
• - ERR_82: Communication Failed.
If the path creation or the path deletion is in progress, "-" is displayed.
-SSIDs: Displays the SSIDs (hexadecimal) setting to RCU. If CU free is specified for RCU, "-" is
displayed.
raidcom modify rcu
This sets the control parameters to specified CU that is specified using two way.
Syntax
raidcom modify rcu {-rcu <serial#> <mcu#> <rcu#> -ssid <ssid>
| -cu_free <serial#> <id> <pid>} -rcu_option <mpth> <rto>
<rtt> [fzd | fze]
Options and parameters
DescriptionOption
Specifies the CU specified by serial number, <mcu#>, and <rcu#>. For XP7 Storage,
specify the number of which 300,000 is added to the serial number for <serial#>. You
-rcu <serial#> <mcu#>
<rcu#>
can use hexadecimal numbers (add 0x prefix ) or decimal numbers for the <mcu#>
and <rcu#>.
Specifies the subsystem ID.-ssid <ssid>
You can use hexadecimal numbers (add 0x prefix) or decimal numbers for the <ssid>.
Specifies CU free specified by serial#, id#, pid# for setting CU for the operational
object. For XP7 Storage, specify the number of which 300,000 is added to the serial
number for <serial#>.
-cu_free <serial#><id><pid>
< id > specifies the storage system type as follows:
• For XP7 use R800.
• For P9500 use R700.
• For XP24000/XP20000 Disk Array use R600.
• For XP12000 Disk Array/XP10000 Disk Array use R500.
< pid> specifies the path group ID (1-255).
Note: The RCU is displayed by default on the GUI of Continuous Access Synchronous,
Continuous Access Journal, or Continuous Access Journal Z when "0" is specified for
<pid>.
Specifies CU control parameters:-rcu_option <mpth> <rto>
<rtt> [fzd | fze]
• <mpth>: minimum number of paths (1-8)
• <rto>: RIO timeout value (10-100) (second) for RIO (Remote IO) setting between
MCU and RCU.
• <rtt> is used to set the round trip time value (1-500) (millisecond) between MCU and
RCU.
• [fzd | fze]: Specify fze to enable the freeze option, or fzd to disable it.
If the freeze option is not specified to the RCU with CU units, the freeze option is
disabled.
198 Configuration setting commands