HP XP P9000 Audit Log User and Reference Guide

DescriptionItem
The name of the host group newly added.HostGrpName
The number of host groups added.Num. of Host Groups
[PROV] Create LDEVs
Example 1
07xx,YYYY/MM/DD,HH:MM:SS.xxx, 00:00,RMI AP,uid=user-name,1,
Task Name,[PROV],Create LDEVs,Basic,Normal end,
from=xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx,,Seq.=xxxxxxxxxx
+{PG,LDKC:CU:LDEV,Start LBA,Emulation,Size,Unit,System Disk,
MP Blade ID}
=[{XX-XX,0xXX:0xXX:0xXX,XXXXXXXX,OPEN-V,XXXXXXXX,
KB,Disable,Auto},
{XX-XX,0xXX:0xXX:0xXX,XXXXXXXX,OPEN-V,XXXXXXXX,KB,Disable,0}],
Num. of LDEVs=2
Basic information for example 1
DescriptionParameter
Create LDEVs was done to basic volumes.Basic
Create LDEVs was done to external volumes.External
Create LDEVs was done to both basic volumes and external volumes.Basic/External
Detailed information for example 1
DescriptionItem
The parity group number.PG
An E at the beginning of a parity group number designates an external volume is present in
that parity group.
The LDKC, CU, and LDEV numbers.LDKC:CU:LDEV
The start LBA.Start LBA
A hyphen (-) is output when not specified.
The emulation type.Emulation
The user-specified capacity.Size
The unit of the CV capacity.Unit
LBA is displayed.
This capacity value can be converted into kilobytes by dividing by two because one block is
512 bytes.
For information about how to convert the capacity value into cylinders, see the section describing
size calculation in HP XP P9000 Provisioning for Mainframe Systems User Guide.
Indicates system disk status. Enable: Enabled, Disable: DisabledSystem Disk
The specified MP blade ID.MP Blade ID
“Auto” indicates the processor blade number is set automatically.
The number of LDEVs.Num. of LDEVs
Provisioning descriptions 131