HP XP P9000 Audit Log User and Reference Guide

Detailed information
DescriptionItem
The operation on the poolCommand
Change: Changing pool information about the threshold and the subscription limit
Change Tier: Changing information about Smart Tiers
Delete: Delete pool
The pool ID of the pool where the settings have been changed or the number of the pool that
have been deleted
Pool ID
The pool typePool Type
Snapshot: Snapshot, Thin Provisioning: Thin Provisioning, Fast Snap: Fast Snap.
Indicates whether the multi-tier mode of the pool is enabled or disabled.Multi Tier Pool
Enable: Enabled, Disable: Disabled
This item is output only when "Command" is "Change Tier".
If Pool Type is Snapshot or Fast Snap, a hyphen (-) is output.
The warning threshold of the usage rate of the pool in percent (%).Warning Threshold(%)
This item is output only when "Command" is "Change".
The depletion threshold of the usage rate of the pool in percent (%).Depletion Threshold(%)
If the depletion threshold is not specified, this percentage is not output.
This item is output only when "Command" is "Change".
If Pool Type is Snapshot or Fast Snap, or if the depletion threshold is not specified, a hyphen
(-) is output.
The reserve amount of the pool where the setting was changed. The unit is percent (%).Subscription Limit(%)
If the reserve amount is not specified, it outputs "Unlimited".
This item is output only when "Command" is "Change".
If Pool Type is Snapshot or Fast Snap, a hyphen (-) is output.
The auto control mode of the created or expanded pool.Tier Management
Auto: Auto, Manual: Manual
This item is output only when "Command" is "Change Tier".
If Multi Tier Pool is anything other than Enable, a hyphen (-) is output.
The cycle of performance monitoring for the pool.Cycle Time
0.5: every thirty minutes, 1: every one hour, 2: every two hours, 4: every four hours, 8: every
eight hours, 24: every twenty-four hours
This item is output only when "Command" is "Change Tier".
If Tier Management is anything other than Auto, a hyphen (-) is output.
The monitoring period of the pool.Monitoring Period
Format: "H1:M1-H2:M2" H1: The time when the monitoring starts (hour) M1: The time when
the monitoring starts (minute) H2: The time when the monitoring ends (hour) M2: The time
when the monitoring ends (minute).
This item is output only when "Command" is "Change Tier".
If Cycle Time is anything other than 24, a hyphen (-) is output.
The monitoring modeMonitoring Mode
Continuous Mode: Continuous mode, Period Mode: Period mode
This item is output only when "Command" is "Change Tier".
If Multi Tier Pool is anything other than Enable, a hyphen (-) is output.
Provisioning descriptions 151