HP XP P9000 Audit Log User and Reference Guide

Table 2 Basic Information in Audit Log File (continued)
File 2 (DKC)File 1 (SVP)ItemNo.
message ID of four, five, or six digits. For
more information about error codes, see
the HP XP P9000 Remote Web Console
Messages.
NOTE: Error codes "xxxx-yyyyy" appear
only for Remote Web Console operations.
An IP address (IPv4 or IPv6) is output for
Remote Web Console, RMI AP and SVP
Host
Identification
13
• A host name is output for commands from
hosts through the SVP.
operations. The IP address may be that of
• A WWN is output for the FC-SP
authentication.
the proxy server or the router depending
on the configuration of the connected
network.
• A WWN is output for commands from
open-system hosts.
No output for RM AP operations. No
output when the user name is <System>.
• A serial number is output for commands
mainframe system hosts.
If both IPv4 and IPv6 are available for
communication between the Remote Web
• If a command comes from other storage
system, the WWN or serial number of the
storage system is output.
Console computer and the SVP, you can
specify the IPv6 address of the SVP in the
Web browser, but the Remote Web
Console secondary window uses IPv4
communication. In this case, IPv4
addresses are output to audit logs.
For details about configuring only IPv6
communication, see the section describing
IPv6 communication in the HP XP P9000
Remote Web Console User Guide.
No outputApplication
Identification
14
• An internal-use ID is output for open-system
hosts.
• An LPR number is output for mainframe system
hosts.
• 0x0000 is output if a command comes from
other storage system.
• No output for other commands.
Same as File 1The serial number of the saved log
information (0000000000 to
Serial number15
4294967295). When the number
reaches 4,294,967,295, it is reset to
0000000000.
Detailed Information
Detailed information in the audit log file 1 (SVP) contains index and setting values. Detail information
in the audit log file 2 (DKC) contains command names and parameters received from a host.
The following shows the symbols used in the detailed information.
Table 3 Symbols Used in Detailed Parameter in Audit Log (SVP)
DefinitionSymbol
'+' or '-' displays at the beginning of a line.+ and -
'+' means the beginning of the index. The number of occurrences of '+' represents the number of indents.
'-' means that the line continues from the previous line.
Connects an index and a setting value.=
Audit log file format 17