HP XP P9000 Audit Log User and Reference Guide

DescriptionItem
The nickname of the device set.Name
The setting name of the system administrator.Contact
The setting location of the device set.Location
Performance Control Descriptions
[Perf Ctl] Change PFCGrp
Example
07xx,YYYY/MM/DD,HH:MM:SS.xxx, 00:00,RMI AP,uid=user-name,1,,
[Perf Ctl],Change PFCGrp,,Normal end,
from=xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx,,Seq.=xxxxxxxxxx
+{PFC Group,Priority,UpperLimit,Mode}
=[{XXXXXXXXXXXXXXXX,Non-Prio,XXXXXXXX,IOPS}],Num. of PFC Groups=1
Detailed Information
DescriptionItem
A PFC group namePFC Group
An attribute specified to an HBA (host bus adapter) in the PFC group after the changePriority
Prio: a prioritized WWN
Non-Prio: a non-prioritized WWN
An upper limit when you specify Non-PrioUpper Limit
When you specify Prio, this information is not output.
The type of rate when you specify an upper limit.Mode
IOPS: the I/O rate
KB/s: the transfer rate
When you specify Prio, this information is not output.
The number of PFC groups whose settings are changedNum. of PFC Groups
NOTE:
• When the attribute of the host bus adapter in the PFC group changes from a prioritized WWN
to a non-prioritized WWN, "Non-Prio" is output to Priority and "0" is output to Upper limit
respectively.
• If multiple changes in settings such as Priority and Upper limit are made in succession and
then Apply is clicked at the end of the operation, these set values are output one by one in
the order they were configured.
[Perf Ctl] Clear PFC Info
Example
07xx,YYYY/MM/DD,HH:MM:SS.xxx, 00:00,RMI AP,uid=user-name,1,,
[Perf Ctl],Clear PFC Info,,Normal end,
from=xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx,,Seq.=xxxxxxxxxx
184 Audit log examples