HP XP P9000 Audit Log User and Reference Guide

[Install] Set CommandDevSec
Example
07xx,YYYY/MM/DD,HH:MM:SS.xxx, 00:00,SVP,uid=user-name,1,,
[Install],Set CommandDevSec,,Normal end,
from=xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx,,Seq.=xxxxxxxxxx
+{LDKC:CU:LDEV,CommandDevSec}=[{0x00:0xXX:0xXX,Disable},
{0x00:0xXX:0xXX,Enable}],Num. of LDEVs=2
Detailed information
DescriptionItem
The LDKC, CU, and LDEV numbers of the logical volume where the command device is set.LDKC:CU:LDEV
Indicates whether the command device security setting is enabled or disabled.CommandDevSec
Disable or Enable will appear.
The number of logical volumes where the command device is set.Num. of LDEVs
[Install] Set DevGrpDef
Example
07xx, YYYY/MM/DD,HH:MM:SS.xxx, 00:00,SVP,uid=user-name,1,,
[Install],Set DevGrpDef,,Normal end,
from=xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx,,Seq.=xxxxxxxxxx
+{LDKC:CU:LDEV,DevGrpDef}=[{0xXX:0xXX:0xXX,Enable}],
Num. of LDEVs=1
Detailed information
DescriptionItem
The LDKC, CU, and LDEV numbers of the volume where the device group definition is specified.LDKC:CU:LDEV
Indicates whether the device group definition is enabled or disabled.UserAuth
Disable or Enable will appear.
The number of logical volumes where the device group definition is set.Num. of LDEVs
[Install] Set Fibre Address
Example
07xx,YYYY/MM/DD,HH:MM:SS.xxx, 00:00,SVP,uid=user-name,1,,
[Install],Set Fibre Address,,Normal end,
from=xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx,,Seq.=xxxxxxxxxx
+{Port,Fibre Addr.}=[{XX,0xXX(xx)},{XX,0xXX(xx)}],Num. of Ports=2
Detailed information
DescriptionItem
The name of the port that the fibre address has been set.Port
The address of the Fibre Channel port after the setting is made.Fibre Addr.
The information outside of the parentheses indicates AL-PA (arbitrated-loop physical address).
The information inside the parentheses indicates the loop ID.
The number of ports where address has been set.Num. of Ports
Install descriptions 97