HP XP7 Audit Log User and Reference Guide (H6F56-96001)

from=xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx,,Seq.=xxxxxxxxxx
+{LDKC:CU:LDEV,UserAuth}=[{0xXX:0xXX:0xXX,Enable}],
Num. of LDEVs=1
Detailed Information
DescriptionItem
The LDKC, CU, and LDEV numbers of the volume where the user authentication is specified.LDKC:CU:LDEV
Indicates whether the user authentication is enabled or disabled.UserAuth
Disable or Enable will appear.
The number of logical volumes where the user authentication is set.Num. of LDEVs
[Install] System Option
Example
08xx,YYYY/MM/DD,HH:MM:SS.xxx, 00:00,SVP,uid=user-name,1,,
[Install],System Option,,Normal end,
from=xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx,,Seq.=xxxxxxxxxx
+Spare Disk Recover=Full Speed
+Disk Copy Pace=Slower
+Copy Operation(Correction Copy)=OFF
+Copy Operation(Dynamic Sparing)=OFF
+Link Failure Threshold=10
+{LDKC:CU:LDEV,Destage}=[{0x00:0x00:0x00,OFF}],
Num. of LDEVs=1
+{LPR,Cache Tuning}=[{System,Level5}],Num. of LPRs=1
+{LPR,Command Control}=[{System,10}],Num. of LPRs=1
+{LPR,Mode,Set}=[{System,0,ON}],Num. of Modes=1
+Debug Mode=Set
Detailed Information
DescriptionItem
Indicates the setting status of Spare Disk Recover.Spare Disk Recover
Interleave: Give priority to the access from the host while executing copy process, Full speed:
Give priority to the copy process.
Indicates the setting status of Disk Copy Pace.Disk Copy Pace
Slower: Low speed, Medium: Medium speed, Faster: High speed
Indicates the setting status of Copy Operation (Correction Copy).Copy Operation
ON: Execute Correction Copy, OFF: Do not execute Correction Copy(Correction Copy)
Indicates the setting status of Copy Operation (Dynamic Sparing).Copy Operation
ON: Execute Dynamic Sparing, OFF: Do not execute Dynamic Sparing(Dynamic Sparing)
The threshold to report link failureLink Failure Threshold
The LDKC number, the CU number, and the LDEV numberLDKC:CU: LDEV
Indicates the setting status of Destage.Destage
ON: Execute write through operation (report the completion of the writing to the host after
the writing to the disk drive has completed).
OFF: Do not execute write through operation (report the completion of the writing to the host
when the data is written in the cache memory).
The number of LDEVsNum. of LDEVs
Install Descriptions 101