HP XP7 Audit Log User and Reference Guide (H6F56-96001)

DescriptionItem
Thin Provisioning: Thin Provisioning, Fast Snap: Fast Snap
Indicates whether the multi-tier mode of the pool is enabled or disabled.Multi Tier Pool
Enable: Enabled, Disable: Disabled
This item is output only when "Command" is "Change Tier".
If Pool Type is Fast Snap, a hyphen (-) is output.
The warning threshold of the usage rate of the pool in percent (%).Warning Threshold(%)
This item is output only when "Command" is "Change".
The depletion threshold of the usage rate of the pool in percent (%).Depletion Threshold(%)
If the depletion threshold is not specified, this percentage is not output.
This item is output only when "Command" is "Change".
If Pool Type is Fast Snap, or if the depletion threshold is not specified, a hyphen (-) is output.
The reserve amount of the pool where the setting was changed. The unit is percent (%).Subscription Limit(%)
If the reserve amount is not specified, it outputs "Unlimited".
This item is output only when "Command" is "Change".
If Pool Type is Fast Snap, a hyphen (-) is output.
The auto control mode of the created or expanded pool.Tier Management
Auto: Auto, Manual: Manual
This item is output only when "Command" is "Change Tier".
If Multi Tier Pool is anything other than Enable, a hyphen (-) is output.
The cycle of performance monitoring for the pool.Cycle Time
0.5: every thirty minutes, 1: every one hour, 2: every two hours, 4: every four hours, 8:
every eight hours, 24: every twenty-four hours
This item is output only when "Command" is "Change Tier".
If Tier Management is anything other than Auto, a hyphen (-) is output.
The monitoring period of the pool.Monitoring Period
Format: "H1:M1-H2:M2" H1: The time when the monitoring starts (hour) M1: The time when
the monitoring starts (minute) H2: The time when the monitoring ends (hour) M2: The time
when the monitoring ends (minute).
This item is output only when "Command" is "Change Tier".
If Cycle Time is anything other than 24, a hyphen (-) is output.
The monitoring modeMonitoring Mode
Continuous Mode: Continuous mode, Period Mode: Period mode
This item is output only when "Command" is "Change Tier".
If Multi Tier Pool is anything other than Enable, a hyphen (-) is output.
The relocation speedRelocation Speed
1: Slowest, 2: Slower, 3: Normal, 4: Faster, 5: Fastest
The result of the operationResult
Normal end: Normal end, Error(xxxx-yyyyy): Abnormal end, Not Execute: Not Executed
xxxx: Part code, yyyyy: Error code
The number of pools where the settings have been changed or the number of pools that
have been deleted
Num. of Pools
The tier numberTier
150 Audit log examples