HP XP7 Audit Log User and Reference Guide (H6F56-96001)

+{S/N,MCU LDKC,MCU,RCU LDKC,SSID,Controller ID,Min.Path,
MIH Time(s),Round Trip Time(ms),FREEZE,Result}
={99998,0x00,0x3F,0x00,0x0004,6,08,015,001,Disable,Nomal end}
(Snip)
+{S/N,MCU LDKC,MCU,RCU LDKC,SSID,Controller ID,Min.Path,
MIH Time(s),Round Trip Time(ms),FREEZE,Result}
={99999,0x00,0x3F,0x00,0x0004,6,08,015,001,Disable,Nomal end}
+Num. of RCUs=xx
Example 3: when using CU Free and not using CU Free coexist
08xx,YYYY/MM/DD,HH:MM:SS.xxx, 00:00,RMI AP,uid=user-name,1,,
[Remote Replication],Change RCU Option,,Normal end,
from=xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx,,Seq.=xxxxxxxxxx
+{S/N,MCU LDKC,RCU LDKC,Path Gr.ID,Controller ID,Min.Path,
MIH Time(s),Round Trip Time(ms),FREEZE,Result}
={99998,0x00,0x00,Default,6,08,015,001,Disable,Nomal end}
(Snip)
+{S/N,MCU LDKC,MCU,RCU LDKC,SSID,Controller ID,Min.Path,
MIH Time(s),Round Trip Time(ms),FREEZE,Result}
={99999,0x00,0x3F,0x00,0x0004,6,08,015,001,Disable,Nomal end}
+Num. of RCUs=xx
Detailed Information
DescriptionItem
The serial number of the RCU on which the RCU option is changedS/N
The LDKC number of the connected LDKCMCU LDKC
The LDKC number of the paired LDKCRCU LDKC
The path group ID of the RCU on which the RCU option is changed. When the path group
ID is default setting, "Default" is output.
Path Gr.ID
The controller ID of the RCU on which the RCU option is changedController ID
7: XP7, 6: P9500, 5: XP24000/XP20000 Disk Array, 19: HUS VM
The CU number of the connected CUMCU
The SSID of the RCU on which the RCU option is changedSSID
The number of minimum paths after the changeMin.Path
The value of RIO MIH (Remote I/O Missing Interrupt Handler) timer after the change (wait
time until data copy from MCU to RCU is complete). The unit is second.
MIH Time(s)
The round-trip response time after the change (delay time for round-trip remote I/O). The
unit is millisecond. This value is output when Continuous Access Synchronous or Continuous
Access Synchronous Z is used.
Round Trip Time(ms)
Indicates whether CGROUP (FREEZE/RUN) PPRC TSO command support is enabled or
disabled. This value is output only when Continuous Access Synchronous Z is used.
FREEZE
Enable or Disable is output.
The result of the operationResult
Normal end: Normal end,
Error(xxxx-yyyyy): Abnormal end
where xxxx: Part code, yyyyy: Error code
The number of RCUs setNum. of RCUs
Remote Replication Descriptions 171