Start Here Guide
Table Of Contents
- Table of Contents
- Setting Up Your Computer
- Putting Your Computer Together
- Connecting a Digital Camera (Photo or Video)
- Connecting Other Devices
- Storing Documentation and Recovery Discs
- Adjusting the Monitor
- Setting Up a Local Area Network
- Setting Up a Wired (Ethernet) Connection
- Integrated Wireless Devices
- Connecting the Wireless LAN Device
- Connecting a Modem
- Connecting Speakers or Microphone
- Using Speakers
- Sound Connector Types
- Connecting a Microphone
- Speaker Configurations
- Connecting 2/2.1 (Two Speakers and a Subwoofer) Audio Speakers
- Connecting 4.1 (Four Speakers and a Subwoofer) Audio Speakers
- Connecting 5.1 (Five Speakers and a Subwoofer) Audio Speakers
- Connecting 7.1 (Seven Speakers and a Subwoofer) Audio Speakers
- Connecting the Computer to a Home Audio System
- Connecting Digital Audio
- Connecting Speakers Using the Creative Sound Blaster X-Fi Sound Card
- Connecting the Television Signal and Video Cables
- Using TV Cables
- Audio and Video Cables
- Connecting the TV Signal Source
- Connecting the Remote Sensor
- Connecting the TV Signal Source When You Have an Existing Setup
- Using Your TV as a Monitor
- Using the Windows Media Center Setup for Optional Setup of Your TV Display
- Disabling the TV-out Option
- Disconnecting the TV
- Connecting to a Monitor or High-Definition TV
- Connecting to a Standard TV
- Getting Help
- Index
46 Start Here
Wall to cable TV set-top box or satellite box to
VCR and TV, using S-video cable or composite
video cable between the box and the VCR or TV
1 Do not detach any cables from your existing setup.
2 Connect an additional cable by doing one of the following:
Connect one end of an S-video cable (not included) to a second output on the set-
top box or satellite box. Connect the other end to the S-video In connector on the
back of the computer.
Or
Connect one end of a composite video cable to a second output on the set-top box
or satellite box. Connect the other end to the S-video to composite video adapter
cable, and then connect the adapter to the S-video In connector on the back of the
computer.
3 If you are using a composite video or S-video cable, you must also connect audio
cables (not included) from your satellite box or set-top box to the Audio In right (red)
and Audio In left (white) connectors on the back of the computer.
4 Connect the remote control sensor cable (emitter), and position it on your set-top box
or satellite box. This enables the computer to change the channel on the box. See
“Connecting the Remote Sensor.”