8.14.01 HP Utility Meter User's Guide (June 2009)

To copy the Utility Meter's configuration:
1. Start the Utility Meter GUI. For details, see Starting the Utility Meter GUI.
2. In the Utility Meter GUI, click the Configure tab, and then click the Copy the Meter's
configuration task button (right pane). This operation may take some time to complete.
When the copy has successfully completed, this task displays a pop-up message with the name of the
copied file. The Copy the Meter's configuration task copies the
/etc/opt/meter/meter.xml configuration file to the /tmp directory of the Utility Meter.
Figure 3-8 Save the Meter's Configuration Message
3. Copy the saved file (which is listed in the Save the Meter's configuration message) from the
/tmp directory to a safe file (for example, CD, network-attached file system, or a flash drive).
4. Click the OK button to close the message window.
If a copy failure occurs, a pop-up message advises you of the status.
3.5 Utility Meter Devices Tasks
After you click the Utility Meter GUI's Devices tab, you can access these user tasks:
• Add Device — This task allows you to add five types of devices:
Add an EVA Device — This task adds an EVA device (Command View server) to the Utility Meter
for metering.
•
• Add an XP Device — This task adds an XP device (Command View server) to the Utility Meter for
metering.
• Add a PPU WBEM Partition/Server — This task adds a PPU WBEM Partition/Server to the Utility
Meter for metering.
• Add a Cisco SAN Switch — This task adds a Cisco SAN switch to the Utility Meter for metering.
• Add an HP/Brocade SAN Switch — This task adds an HP/Brocade SAN switch to the Utility
Meter for metering.
• Modify Device — This task allows you to perform three types of modifications to devices:
Change a non-URS Disk Array to URS — This task changes a non-URS disk array to URS or a URS
disk array to non-URS. Only disk arrays that are labeled URS Device are metered by the Utility
Meter.
•
• Change PPU WBEM Partition/Server Configuration Parameters — This task changes the
configuration parameters (such as login credentials) for a PPU WBEM Partition/Server.
• Change HP/Brocade Switch Configuration Parameters — This task selects switches maintained
by an HP/Brocade SMI-S Agent to be monitored.
• View Device — This task displays information about a PPU WBEM Partition/Server.
• Remove Device — This task removes a device from the set of devices being metered by the Utility Meter.
52 Performing Utility Meter Tasks