PCI Error Handling Product Note 3rd Edition

Activity : Target slot powered on, drivers resumed, OK to start using the cardTarget
slot : 0-1-1-0
G. Execute the olrad -q command again to confirm the card has been resumed:
Recovery Using the Attention Button
To use the Attention Button to recover from a PCI error, refer to the Interface Card OL* Support
Guide, Manufacturing Part Number B2355-90862, for instructions on using the Attention Button,
then use the Attention Button to complete the same steps that are illustrated in “Recovery Using
the olrad Command” (page 12):
1. Confirm the driver/card is suspended
2. Confirm card is in an error state
3. Power off the slot
4. Confirm the slot power is off
5. Resume the card
6. Confirm the card has been resumed
PCI Error Handling Documentation
The documentation that supports this release of the PCI Error Handling feature consists of:
• PCI Error Handling Product Note, March 2007, Manufacturing Part Number 5992-0539 — available
in the High Availability category at http://docs.hp.com/en/ha.html
• SW Depot web page — available from the HP Software Depot at http://h20293.www2.hp.com
• olrad manpage — after installing the PCI Error Handling feature, enter man olrad from
the command line to view the olrad manpage that includes PCI Error Handling information.
• Interface Card OL* Support Guide, September 2004, Manufacturing Part Number B2355-90862 —
available at: http://docs.hp.com
• Patch Management User Guide for HP-UX 11.x Systems, February 2007, Manufacturing Part
Number 5991-6449 — available at: http://docs.hp.com
Defects Fixed in This Version
The following defect is fixed in the PCI Error Handling product for July 2008 release.
PCI Error Handling Documentation 15