PCI / PCIe Error Recovery Product Note, September 2010

7. After the card has been resumed, a recovery message will be displayed in the console, for
example:
Hardware path 0/0/0 Successfully recovered from PCI Error
8. If the olrad -R command does not succeed, you have a persistent PCI error condition.
There is a high probability that the I/O card is defective. A failure message will be displayed
on the console, for example:
Automatic PCI Error Recovery Operation failed at Hardware path 0/0/0.
Path may be recovered using a Manual Error Recovery operation.
Refer to olrad(1m) man page for details
The olrad -q command will show the slot as being suspended (Susp Mode = Yes) and
the power will be off (Pwr = Off).
At this point you have two options:
• You can perform an OL* online replacement operation to replace the I/O card with an
I/O card that has the same HP Manufacturing Part Number and the same (or later)
release version number.
• You can perform an OL* online deletion operation to delete the card and the driver
instance associated with that card. After a successful online deletion, the slot is available
to be used with another I/O card. If you want to perform an online addition operation
to add a different I/O card to the slot, see the Interface Card OL* Support Guide.
NOTE: Manual PCI Error Recovery operation to restore the card is supported only on legacy
platforms, and is not supported on HP Superdome 2 platform. Manual PCI Error Recovery
operation will be supported on HP Superdome 2 platform when the OL* capability is enabled
on the new platform.
OL* online replacement operations can be performed with the pdweb GUI, with the olrad
command, or with a hardware attention button procedure.
OL* online deletion operations can be performed with the pdweb GUI, or with the olrad
command.
14 PCI / PCIe Error Recovery Product Note