Fabric Clustering System 24-port 4x Fabric Copper Switch Installation Guide, March 2005

HP-UX Integrity Installation Overview & Planning
Install HP Fabric Clustering System Switches
Chapter 1
14
Step 5. Fit the sliding rails over the fixed rails with the flanges facing outward until the flanges meet the
rack.
Figure 1-10 Fit Sliding Rail over Fixed Rail
Step 6. Attach the rails to the rack, both sides as shown in Figure 1-11.
CAUTION Keep switch supported until rail is attached to the rack.
Figure 1-11 Attach Sliding Rail to Rack
Step 7. Securely attach all rails to the rack.
Remove Shipping Sleeve
Underneath each power supply is a shipping sleeve. Take the bezel off and remove the entire sleeve by gently
pulling on the tab. Replace the bezel.
Figure 1-12 Remove Shipping Sleeve From Under Power Supply