Fabric Clustering System 24-port 4x Fabric Copper Switch Installation Guide, March 2005

ProLiant Linux Installation Overview & Planning
HP Fabric Clustering System 24-Port Switch
Chapter 2
20
• Twelve T-25 Torx screws for attaching rails and support bracket to rack
• Twelve clip nuts for mounting in a 10000 Series rack
• Twelve clip nuts for mounting in a Rack System/E rack
• Two power cables, IEC C14
• This installation guide
• Important Safety Instructions booklet
• Limited Warranty and Material Limitations Documentation
HP Fabric Clustering System 24-Port Switch
376227-B21 HP 24-port 4x Fabric Copper Switch
Figure 2-1 Front View of Switch
Figure 2-2 Rear View of 24-Port Switch
Figure 2-3 Stylized View of Switch Connectors
Install HP Fabric Clustering System Switches
This section describes how to install the switch in a standard HP rack.
If the switch is already installed in a rack, proceed to “Remove Shipping Sleeve” on page 23.
Power Plug
Power Plug
Console Port
Management Port
(24) Switch Cluster Connections