AH303A PCIe SC44Ge SAS Host Bus Adapter for Integrity Servers Support Guide, September 2009

Slot # : 25
Target ID : 33
State : Ready (RDY)
Size (in MB)/(in sectors) : 70007/143374738
Manufacturer : HP
Model Number : DH072ABAA6
Firmware Revision : HPD2
Serial No : 3PD09M7500009742SMWP
Drive Type : SAS
Target on ID #34
Device is a Enclosure services device
Enclosure # : 2
Slot # : 26
Target ID : 34
State : Standby (SBY)
Manufacturer : HP
Model Number : MSA70
Firmware Revision : 2.02
Serial No :
Drive Type : SAS
------------------------------------------------------------------------
Enclosure information
------------------------------------------------------------------------
Enclosure# : 1
Logical ID : 500605B0:00351710
Numslots : 8
StartSlot : 1
Start TargetID : 0
Start Bus : 0
Enclosure# : 2
Logical ID : 50014380:00019E80
Numslots : 26
StartSlot : 1
Start TargetID : 0
Start Bus : 0
NOTE: Integrated RAID (IR) is not supported with external SAS devices.
Physical device status values are as follows:
Online (ONL) The disk is operational and is part of a logical drive.
Ready (RDY) The disk is ready for use as a normal disk drive.
Available (AVL) The device is operational, but it might not be ready for use; for example,
it is not spun up, its block size is incorrect, or its media is removable.
Standby (SBY) The device is not a hard disk.
FORMAT
Use the FORMAT command to perform a low-level format of a disk drive.
Syntax
cfggen <controller #> format <Encl:Bay> [noprompt]
Parameters
<controller #> A SAS controller number between 0 and 255. See “LIST (page 41).”
<Encl:Bay> The enclosure number and bay number that identifies the disk to be
formatted.
[noprompt] An option to eliminate warnings and prompts.
40 Configuring the Adapter Offline