AH303A PCIe SC44Ge SAS Host Bus Adapter for Integrity Servers Support Guide, September 2009

WARNING! Performing a low-level format on a hard disk drive destroys all data stored on
that disk. Do not interrupt the operation. Doing so can result in irreparable damage to the hard
disk.
Operation
Unless you include <noprompt> on the command line, warning messages appear. You must
answer a series of prompts or the command is aborted. The answers are case sensitive and you
must enter them in upper case.
This command returns to a shell prompt when the format operation is complete. Depending on
the capacity and model of disk drive, this can take a considerable amount of time.
LIST
Use the LIST command to view information about all AH303A adapters, HP 8 Internal Port SAS
Controllers, and HP Multi Port SAS Controllers in the system. You can also use the LIST command
to determine the <controller #> parameter required by the other cfggen commands.
Syntax
cfggen list
Parameters
None.
Sample Output
Following is an example output from a system with one HP 8 Internal Port SAS Controller and
one AH303A Controller:
fs0:\EFI30305> cfggen list
LSI Logic SAS Raid Configuration Utility v1.00.13.00
Vendor Device Segment
Index ID ID ID Bus Device Func
------ ------ ------ ------- --- ------ ----
0 1000h 0054h 0000h 1h 01h 00h LSI 1068 SAS Host Adapter
1
1 1000h 0058h 0000h 3h 00h 00h LSI 1068E SAS Host Adapter
2
21
HP AH303A SC44Ge SAS Host Bus AdapterHP 8 Internal Port SAS Controller
LOCATE
Use the LOCATE command to turn the locate LEDs on and off.
Syntax
cfggen <controller #> locate
Parameters
<controller #> A SAS controller number between 0 and 255.
Unsupported Commands
You can use the cfggen utility to configure several different HP controllers. Some of these
controllers have Integrated RAID (IR) functionality; however, IR is not supported on the AH303A.
If you use a RAID-related cfggen command with an AH303A adapter, an error message similar
to the following appears:
The cfggen Utility 41