AH303A PCIe SC44Ge SAS Host Bus Adapter for Integrity Servers Support Guide, September 2009

ext_bus 4 0/2/0/0/0/0.0.2 sasd_vbus CLAIMED INTERFACE SAS Device Interface
target 3 0/2/0/0/0/0.0.2.6 tgt CLAIMED DEVICE
disk 42 0/2/0/0/0/0.0.2.6.0 sdisk CLAIMED DEVICE HP DH072ABAA6
/dev/dsk/c4t6d0 /dev/rdsk/c4t6d0
By default, for each hardware module on the system ioscan displays the hardware path to the
hardware module, the class of the hardware module, and a brief description.
If the device is connected but not found, it is in a “no hardware” state. If the device is in a no
hardware state, use sasmgr to determine the state of the I/O card. See “Displaying General
Statistics and Information” (page 49).
The sasmgr Utility
Use the sasmgr utility to manage HP-UX Serial Attached SCSI (SAS) mass storage core I/O
controllers. For HP-UX 11i v2, the sasmgr command syntax is as follows:
SYNTAX
Path: /opt/sas/bin
sasmgr [-h][-f] add -D device_file -q raid -q level=raid_level
-q enc_bay=enc:bay[,enc:bay] [-q size=size] [-q rebuild_rate=rate]
sasmgr [-h][-f] add -D device_file -q raid -q spare -q enc_bay=enc:bay
sasmgr [-h][-f] bdr -D device_file -q lun={all | lun_dsf}
sasmgr [-h] clear_stat -D device_file
sasmgr [-h] clear_stat -D device_file -q all
sasmgr [-h] clear_stat -D device_file -q phy={all | phy_id}
sasmgr [-h] clear_stat -D device_file -q phy_in_port={all | phy_id}
sasmgr [-h] clear_stat -D device_file -q target={all | sasaddr}
sasmgr [-h][-f] delete -D device_file -q raid -q raid_vol={rvol_id |
all}
sasmgr [-h][-f] delete -D device_file -q raid -q spare
sasmgr [-h][-f] disable -D device_file
sasmgr [-h][-f] download -D device_file -q downloadfile=filename
-q enc_bay=enc:bay
sasmgr [-h][-f] download -D device_file -q downloadfile=filename
-q ctrl=ctrl_device_file
sasmgr [-h] enable -D device_file
sasmgr [-h] get_info -D device_file
sasmgr [-h] get_info -D device_file -q lun={all | lun_dsf}
sasmgr [-h][-v] get_info -D device_file -q lun={all | lun_dsf}
-q lun_locate
sasmgr [-h] get_info -D device_file -q pci_id
sasmgr [-h] get_info -D device_file -q phy={all | phy_id}
sasmgr [-h] get_info -D device_file -q phy_in_port={all | phy_id}
sasmgr [-h] get_info -D device_file -q raid
sasmgr [-h] get_info -D device_file -q reg={all | offset}
[-q reg_type={ pci_config | mmio }]
sasmgr [-h] get_info -D device_file -q smp=file_name
46 Configuring and Troubleshooting the Adapter Online