HP Performance Optimized Datacenter 20c User Guide - North America

Environmental control system 50
Setting the dimensions of the ECS
To set the dimensions of the ECS:
1. Select Dimensions.
2. Select the dimensions (metric or imperial) to be displayed throughout the ECS interface.
3. Select Save.
Setting the fan controls for each fan control zone
The current fan speed appears on each fan control zone.
HP recommends leaving the fans in AUTO mode during normal operation.
To configure the fan speed:
1. Select the Auto/Manual in the fan control zone you want to change.
2. If you are setting the fan to Manual mode, select the fan speed (0-4) by pressing the corresponding
number.
3. Select Save to store the new parameters in the system configuration file.
Setting the IP address for each power meter
The current, preset static IP address appears above the Change IP address button. Change the IP address of
a power meter to network multiple meters together or to resolve an IP address conflict.
To configure an IP address:
1. Select Change IP Address.
A keypad appears.
2. Enter the IP address.
3. Select Save to store the new parameters in the system configuration file.
Advanced System Configuration screen
You can only access this screen after you have entered a service-level password.