HP Performance-Optimized Datacenter, 12 m (40 ft) User Guide

Environmental control system 38
Alarm Meaning Solution
4 If you are not within your service
contract, repair the source of the
leak.
Change filter* The return air filters are full. Replace the return air filters.
High temperature
The cold aisle temperature has
surpassed the set point temperature.
Check to make sure that you have
water flowing into your HP POD and
that the fans are blowing. If you are
still within your service contract,
contact HP service.
Low temperature The cold aisle temperature is too low.
Check your HP POD components to
make sure components are operating
as normal. If you are still within your
service contract, contact HP service.
*The change filter alarm is only relayed to your ECS if you have the optional filter replacement sensor installed.
Snoozing alarms
While viewing HP POD status points, alarms will continue to pop up on your menu bar. The alarms are
normal during the commissioning process.
To snooze the alarms:
1. When the alarm pane appears, select Snooze.
2. Select View from the Main Menu bar.
3. Select the Enable Alarm Pop-Ups to uncheck the box. The alarms will no longer appear until you re-
enable the alarm pop-ups.