HP Performance Optimized Datacenter 240e North America (Adiabatic) Maintenance and Service Guide

Removal and replacement procedures 28
You need a screwdriver and scissors for installation.
Removing the magnetic contacts
1. Remove the two screws that secure the upper magnet (1).
2. Cut the tie wrap (2), and then loosen the nut on the POD structure that secures the wire.
3. Pull the wire all the way through to the point of entry or ECS panel (3).
Replacing the magnetic contacts
1. Feed the wire all the way through from the point of entry or ECS panel (1).
2. Tighten the nut on the POD structure that secures the wire, and then replace the tie wrap (2).
3. Secure the magnet to the bracket using two screws (3).