HP Performance Optimized Datacenter 240e North America (Adiabatic) Maintenance and Service Guide

Removal and replacement procedures 31

Replace the tamper cover (1), and then replace the three screws that secure the tamper cover (2).

Exhaust fan damper

Each Adiabatic unit contains 10 exhaust fan dampers.

You need a screwdriver for installation.

Removing the exhaust fan damper

1. Remove the 10mm bolts that secure the exhaust fan damper guard to the exhaust fan damper (1), and

then remove the exhaust fan damper guard (2).

2. Remove the U-bolt from the actuator assembly by removing the two nuts and the two bolts that secure the

U-bolt to the actuator assembly, and then slide the U-bolt off (1).