- Hewlett-Packard Printer User Manual

ManualsBrandsHP ManualsPrinterHP Photosmart 3100

HP Photosmart 2600/2700 series all-in-one

User Guide

HP Photosmart 2600/2700 series all-in-one

User Guide

phone cord

4 x 6 in

(10 x 15 cm)

photo paper

Start Here

HP Photosmart 3100 All-in-One series Setup Guide

* Purchased separately.

The contents of your box

may differ.

Windows CD

Macintosh CD User Guide

ink cartridges

power cord

USB cable*

control panel

faceplate (may

be pre-attached)

Important: Do not connect the USB cable until this

guide instructs you to or the software may not install

properly.

If you have problems during setup, see Troubleshooting later in the guide.

Remove all tape and lift display

Locate components

a Remove all tape. For best

viewing, remove the protective

ﬁ lm from the color graphics

display.

b Lift the display.

2-wire phone

adapter (optional)

Summary of content (8 pages)

PAGE 1
Start Here Important: Do not connect the USB cable until this guide instructs you to or the software may not install properly. 1 If you have problems during setup, see Troubleshooting later in the guide. 2 Remove all tape and lift display a b 3 a Remove all tape. For best viewing, remove the protective film from the color graphics display. b Lift the display. Locate components Windows CD ink cartridges phone cord 4 x 6 in (10 x 15 cm) photo paper USB cable* * Purchased separately.
PAGE 2
4 Attach the control panel faceplate (if not attached) a Lift the lid. b Position the control panel faceplate over the buttons on the device. c Press down firmly on all edges of the overlay to secure it. Make sure all buttons are visible and not blocked. The control panel faceplate must be attached for the HP All-in-One to work! 5 Load paper trays Main tray: a c b d Load plain white paper in the bottom paper tray. Plain paper is needed for alignment.
PAGE 3
6 Connect the power cord Important: Do not connect the USB cable until instructed later in this guide. 7 Connect the supplied phone cord Connect one end of the supplied phone cord to the phone port on the left (1-LINE) and the other to a wall jack. To connect an answering machine or use your own phone cord with the 2-wire adapter, see the User Guide. 8 On Press the On button and configure a After you press the On button, the blue light flashes, and then becomes solid. This may take up to a minute.
PAGE 4
9 Open the access door a 10 b Lift latches inside of the device a b 4 • HP All-in-One a Squeeze the bottom of each latch to release it, and then lift the latch. b Lift all six latches.
PAGE 5
11 a Insert all six ink cartridges Match the color and pattern of the ink cartridge to the color and pattern on the print carriage. a Push the black ink cartridge into the first slot on the left. Close the latch. b Repeat with each of the color ink cartridges. c Make sure each latch is secure. b c 12 a b Close the access door and follow the prompts a After you close the access door, a prompt appears to load plain white paper. Make sure paper is loaded, and then press OK to start the process.
PAGE 6
13 Turn on your computer a Turn on your computer, login if necessary, and then wait for the desktop to appear. b Close any open programs. 14 Insert the correct CD Windows Users: Macintosh Users: Note: If the startup screen does not appear after you insert the CD, double-click My Computer, double-click the CD-ROM icon, and then double-click setup.exe. a Insert the HP All-in-One Windows CD. b Follow the onscreen instructions to install the software.
PAGE 7
15 Connect the USB cable Windows Users: Macintosh Users: a Follow the onscreen instructions until you see the prompt to connect the USB cable. (This may take several minutes.) Once the prompt appears, connect the USB cable to the port on the back of the HP All-in-One, and then to any USB port on your computer. a Connect the USB cable from your computer to the USB port on the back of the device. b Double-click the HP All-in-One installer icon.
PAGE 8
*Q5831-90167* *Q5831-90167* Q5831-90167 16 Congratulations! After you complete software installation, you are finished. To learn about printing photos from memory cards and other features, see the User Guide and online help. For additional help, see www.hp.com/support. Troubleshooting Problem: A Paper Jam message appears. Action: Remove the back access door, and then gently pull out any paper. Turn the device off, and then on. Load the paper again.