3Com Switch 8800 Family Configuration Guide

112 CHAPTER 15: PORT ISOLATION CONFIGURATION
Configuring Isolated
Ports for an Isolated
Group
Configure the upstream port
in the isolated group
port-isolate uplink-port
group isolate-group-id
Required
■ You can configure the
uplink port for the isolated
group only after you create
the isolated group
■ The upstream port can
only be an Ethernet port
■ You can configure only
one upstream port for one
isolated group. And the
uplink port can be an
aggregation group, but
not a static or dynamic
aggregation group
Query isolation information
display port-isolate group [
isolate-group-id ] [ verbose ]
You can carry out this
command in any view
Table 96 Configuring an uplink port in the isolated group
Operation Command Description
Tabl e 97 Configuring isolated ports for the isolated group
Operation Command Description
Enter system view system-view -
Enter Ethernet port view
interface interface-type
interface-number
Required
Configure isolated ports for
the isolated group
port-isolate group
isolate-group-id
Required
■ You can configure isolated
ports for the isolated
group only after you create
the isolated group. The
isolated port can only be
configured as an Ethernet
port
■ One port can join only one
isolated port
■ One port can be either an
isolated port or an uplink
port, but not both an
isolated port and an uplink
port in the same isolated
group
■ If the isolated port is a
member of an aggregation
group, other ports in the
aggregation group will
also join the isolated group
Query isolation information
display port-isolate group [
isolate-group-id ] [ verbose ]
You can carry out this
command in any view