3Com Switch 8800 Family Firewall Module Configuration and Command Reference Guide

210 CHAPTER 14: FIREWALL CONFIGURATION COMMANDS
Description
Use the display secblade module command to view the Firewall module
information.
Example
# Display the Firewall module information.
[SW8800]display secblade module newsec
module newsec:
security-vlan: 10,20,30
secblade-interface: Vlan-interface192
vlan passing: 10,20,30,192
map to slot: 5
map to slot Syntax
map to slot slot-number
undo map to slot slot-number
View
Firewall module view of the switch
Parameter
slot-number: The number of the slot where the Firewall module is located.
Description
Use the map to slot command to map the current module to the Firewall module
corresponding to the slot number.
Use the undo map to slot command to cancel the mapping relation.
By default, no module is mapped to any card.
Example
# Map the current module to the Firewall module in slot 2.
[3Com-secblade-newsec] map to slot 2
secblade aggregation
slot
Syntax
secblade aggregation slot slot-number
undo secblade aggregation slot slot-number
View
System view of the switch
Parameter
slot-number: The number of slot where the Firewall module is located.
Description
Use the secblade aggregation slot command to configure the Firewall module
interface aggregation.