H3C S7500 Series Ethernet Switches Command Manual

Command Manual – Infomation Center
H3C S7500 Series Ethernet Switches Chapter 1
Information Center Commands
1-13
View
System view
Parameters
channel-number: Channel number, ranging from 0 to 9, that is, the system has ten
channels.
channel-name: Channel name, by default, the names of channels 0 to channel 9 are
console, monitor, loghost, trapbuffer, logbuffer, snmpagent, channel6, channel7,
channel8, and channel9.
Description
Use the info-center snmp channel command to set the channel through which
information is output to the SNMP agent.
Use the undo info-center snmp channel command to restore the default channel
through which information is output to the SNMP agent.
By default, the system outputs information to SNMP Agent through channel 5.
Related commands: snmp-agent, display info-center.
Examples
# Configure the system to output information to the SNMP agent through channel 6.
<H3C> system-view
System View: return to User View with Ctrl+Z.
[H3C] info-center snmp channel 6
1.1.14 info-center source
Syntax
info-center source { module-name | default } channel { channel-number |
channel-name } [ debug { level severity | state state }* | log { level severity | state
state }* | trap { level severity | state state }* ]*
undo info-center source { module-name | default } channel { channel-number |
channel-name }
View
System view
Parameters
modu-name: Module name. Refer to Table 1-4 for the detail.