H3C S7500 Series Ethernet Switches Command Manual

Command Manual – HWPing
H3C S7500 Series Ethernet Switches Chapter 1
HWPing Commands
1-3
Description
Use the display hwping command to display test result(s).
If a test group is specified using the arguments of administrator-name and
operation-tag, the system displays only the test result of the group; if not, it displays the
test results of all the test groups.
Related commands: test-enable.
Examples
# Use the display hwping results command to display the test result of the test group
whose administrator name is administrator and operation tag is icmp.
<H3C> display hwping result administrator icmp
HWPing entry(admin administrator, tag icmp) test result:
Destination ip address:1.1.1.99
Send operation times: 10 Receive response times: 10
Min/Max/Average Round Trip Time: 2/5/2
Square-Sum of Round Trip Time: 66
Last complete test time: 2000-4-2 7:59:54.7
Extend result:
SD Maximal delay: 0 DS Maximal delay: 0
Packet lost in test: 0%
Disconnect operation number: 0 Operation timeout number: 0
System busy operation number: 0 Connection fail number: 0
Operation sequence errors: 0 Drop operation number: 0
Other operation errors: 0
Table 1-1 Description on the fields of the display hwping result command
Field Description
Destination ip address Destination IP address
Send operation times Number of times the operation is sent
Receive response times
Number of times of successful test
operations
Min/Max/Average Round Trip Time
Minimum/maximum/average round-trip
time
Square-Sum of Round Trip Time The square sum of round trip time
Last complete test time Time of the last successful test
SD Maximal delay
Maximal delay from the source to the
destination
DS Maximal delay
Maximal delay from the destination to
the source